System Commissioning; Indicators And Buttons; Setting Inverter Parameters Via Lcd - Goodwe ETC Series User Manual

User Manual V1.0-2023-04-30

8 System Commissioning

8.1 Indicators and Buttons

Indicator Status
Power
Operating
Fault

8.2 Setting Inverter Parameters via LCD

• The LCD display automatically turns on and enters the main page after the inverter is
powered on.
• A password is required to access the settings page, contact the after-sales service center to
obtain one.
• Inverter firmware version shown in this document is V00.0. Coummunication version: V1.0.
The screenshots are for reference only. The actual interface may differ.
• The name, range, and default value of the parameters are subject to change or adjustment.
The actual display prevails.
• The power parameters should be set by professionals. To prevent the generating capacity
from being influenced by wrong parameters
LCD Button Description
Direction button
• Short press the direction button: switch to submenus or adjust the parameter values.
• Short press the enter button: go to the next level submenu.
• Long press the enter button: set the parameters after adjusting the values.
• Short press the exit button: back to the upper level menu.
ON= The equipment is power on.
OFF= The equipment is power off.
ON = The system is ready.
BLINK = The system is starting.
OFF =The system is not working.
ON = A fault has occurred.
BLINK 1 = Back-up output overload / reduce load.
OFF = No fault.
NOTICE
39
08 System Commissioning
Description
Enter button
Exit button