Multi-turn actuators
TR-M30X – TR-M1000X
8.2.1.
Type of seating setting via the device menu
Information
How to proceed
Information
2.
Torque switching
➭
page 40, Torque seating setting via the device menu
3.
Limit switching
➭
page 41, Limit switching setting via the device menu
Valve damage due to incorrect setting!
→ The type of seating setting (limit or torque seating) must match the selection for
the valve.
→ Only change the setting with prior consent of the valve manufacturer.
Depending on the version, the actuator settings are performed either via the Combi-
Switch or the magnetic pen control panel.
Actuators in version with Combi-Switch:
Operate the yellow shuttle dial
.
Operate the black selector switch
menu
(Enter) or to go one step back ESC (Escape).
Actuators in version with control panel for magnetic pen:
Use the magnetic pen to tap
Use the magnetic pen to tap
to go back one step, tapping ESC (Escape).
1.
Open device menu.
Information: If the ID of the indicated page starts with M, PRM, ..., you have
already entered the device menu. For further information, refer to:
➭
page 14, Open device menu (Combi-Switch
➭
page 15, Open device menu (magnetic pen control panel
2.
Select menu M0086 or M0087:
Customer settings M0041
Type of seating M0012
End position CLOSED M0086
End position OPEN M0087
The display shows parameter PRM0578 or PRM009.
Figure 39: For user levels
Use
(Enter) to change from user levels
information, refer to: ➭
page 17, Change user level
Figure 40: For user levels
of the Combi-Switch to scroll within the menu
(outer ring), either to confirm the selected
for browsing through the menu.
(Enter), either to confirm the selected menu or
version).
1–3 (read parameters only):
1–3 to a higher user level. For further
4–6 (settings can be changed):
Commissioning
version).
39