Configuring The Module For Firmware Upgrades - evertz 7735CEM Manual

9.3.

CONFIGURING THE MODULE FOR FIRMWARE UPGRADES

The following method can be used to upgrade the firmware in the CEM card. You can also use the
UPGRADE menu item located on the UTILITIES menu to upgrade the firmware.
UPGRADE The UPGRADE jumper J2, is used when firmware upgrades are being done to the
module. For normal operation it should be installed in the RUN position. See the
Upgrading Firmware chapter in the front of the binder for more information.
To upgrade the firmware in the module unit pull it out of the frame. Move Jumper J2
into the UPGRADE position. Install the Upgrade cable provided (located in the vinyl
pouch in the front of this manual) onto header J1 at the card edge. Re-install the
module into the frame. Run the upgrade as described in the Upgrading Firmware
chapter in the front of the binder. Once the upgrade is completed, remove the
module from the frame, move J2 into the RUN position, remove the upgrade cable
and re-install the module. The module is now ready for normal operation.
Gray background indicate un-implemented or un-tested features
7735CEM Composite Encoder with Monitoring
Revision 1.1.1
7700 MultiFrame Manual
7735CEM-55