Setting The Vertical Intensity; Setting The Detail Gain; Configuring The Audio Settings - evertz 7700 Manual

7700 MultiFrame Manual
7714HDC High Quality Down Converter

6.5.12. Setting the Vertical Intensity

Proc Functions
Vertical Inensity
0-100%

6.5.13. Setting the Detail Gain

Proc Functions
Detail Gain
0 to 127
6.6.

CONFIGURING THE AUDIO SETTINGS

The SMPTE 272M and 299M standards permit up to 4 groups of 4 audio channels to be embedded into
the serial digital video bitstream. The down converter de-embeds two groups of audio from the serial
digital input video that are the source for re-embedding on the serial digital output video. The down
converter also has 4 discrete AES inputs that can be selected as the source for re-embedding. The Audio
menu items are used to configure the de-embedder and embedder groups, sample rate converters and to
adjust the audio throughput delay. The chart below shows the items available in the Audio menu.
Sections 6.6.1 to 6.6.2 give detailed information about each of the menu items.
De-embedder A
De-embedder B
Embedder Group A
Embedder Group B
Audio Delay
SRC Mode
Input Ch 1 & 2 Source
Input Ch 3 & 4 Source
Input Ch 5 & 6 Source
Input Ch 7 & 8 Source
7714HDC - 26
Selects the intensity of the vertical enhancement process, as a ratio of the
Horizontal enhancement.
The range is 0 to 100% in steps of 25%.
Where 0% refers to no Vertical enhancement and 100% provides a Vertical
intensity that is equivalent to the Horizontal.
Selects the amount of detail that is present in the picture.
Sets the audio group for de-embedder A (Channels 1 to 4)
Sets the audio group for de-embedder B (Channels 5 to 8)
Sets the audio group destination for embedder A
Sets the audio group destination for embedder B
Adjusts the audio delay from the nominal video delay
Sets the mode of the Sample Rate Converters
Sets the source of audio channels 1 and 2
Sets the source of audio channels 3 and 4
Sets the source of audio channels 5 and 6
Sets the source of audio channels 7 and 8
Revision 1.1