Table of Contents
Advertisement
6.
ON SCREEN MENUS
6.1.
NAVIGATING THE ON SCREEN MENU SYSTEM
A toggle switch and pushbutton allow card edge navigation of a set of on-screen menus used to configure
the card. To enter the on-screen menu system, press and hold the pushbutton for 3 seconds. This will
bring you to the main Setup menu where you can use the toggle switch to move up and down the list of
available sub-menus. An arrow (
which item you are currently choosing. Once the arrow is on the desired item, press the pushbutton to
select the next menu level.
On all menus, there are two extra selectable items: Back and Exit. Selecting Back will take you to the
previous menu (the one that was used to get into the current menu) while Exit will return the display to its
normal operating mode. On the main menu, BACK and EXIT will both take you to the normal operating
mode.
Once in a sub-menu, there may be another menu layer, or there may be a list of parameters to adjust. If
there is another set of menu choices, use the toggle switch to select the desired menu item and press the
pushbutton.
To adjust any parameter, use the toggle switch to move up or down to the desired parameter and press
the pushbutton. The arrow will move to the right hand side of the line (
adjust the parameter. Using the toggle switch, adjust the parameter to its desired value. If the parameter
is a numerical value, the number will increase if you lift the toggle switch and decrease if you push down
on the toggle switch.
When you have stopped at the desired value, depress the pushbutton. This will update the parameter to
the selected value and move the arrow back to the left side of the parameter list (
and adjusting other parameters or use the BACK or EXIT commands.
) moves up and down the left hand side of the menu items to indicate
Revision 1.1
7700 MultiFrame Manual
7714HDC High Quality Down Converter
) indicating that you can now
). Continue selecting
7714HDC - 11
Advertisement
Table of Contents
