Table of Contents
Advertisement
7.
JUMPERS
MODULE STATUS
SIGNAL PRESENT
GENLOCK
Run
Upgrade
J7
FRAME
STATUS
ON
OFF
7.1.
SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED
BY THE GLOBAL FRAME STATUS
FRAME STATUS: The FRAME STATUS jumper J5 located at the front of the main module determines
whether local faults (as shown by the Local Fault indicator) will be connected to the
7700FR frame's global status bus.
To monitor faults on this module with the frame status indicators (on the PS FRAME
STATUS LED's and on the Frame's Fault Tally output) install this jumper in the On
position. (Default)
When this jumper is installed in the Off position, local faults on this module will not be
monitored.
7.2.
CONFIGURING THE MODULE FOR FIRMWARE UPGRADES
Firmware updates can be performed using the Upgrade menu item on the Utilities menu (see section
6.10.5) or using the UPGRADE jumper.
UPGRADE:
The UPGRADE jumper J7, is located near the front card edge and is used when
firmware upgrades are being done to the module. For normal operation it should be in
the RUN position as shown in the diagrams above. See the Upgrading Firmware
chapter in the front of the binder for more information.
To upgrade the firmware in the module unit pull it out of the frame. Move Jumper J7
into the UPGRADE position. Install the Upgrade cable provided (located in the vinyl
pouch in the front of this manual) onto header J2 at the card edge. Re-install the
module into the frame. Run the upgrade as described in Upgrading Firmware chapter.
Once the upgrade is complete, remove the module from the frame, move J7 into the
RUN position, remove the upgrade cable and re-install the module. The module is now
ready for normal operation.
EVERTZ (C) 7714HDC
SFF POWER
GND
+12V
Figure 7-1: Location of LEDs and Jumpers
Revision 1.1
7700 MultiFrame Manual
7714HDC High Quality Down Converter
SDI OUT/
J25
Composite
SDI OUT/
J26
Composite
75
HIZ
+5V +12V
J21
J19
REF TERM
GPI LEVEL
7714HDC - 37
Advertisement
Table of Contents
