Table of Contents
Advertisement
Section 3: Operation
Using Program Modes
Custom programs will appear in alphabetical order at the bottom of the Mode Selection Screen. If there are
multiple programs tapping SCROLL
General Preparation:
•
Confi rm the correct tubing has been selected and is properly loaded into the pump drive (for further
information see
•
Confi rm all fl uids and containers are ready.
•
Switch the drive on using the power switch located at the rear of the drive. NOTE: If User Management
is enabled you may be prompted for a username and password (For further information see
Management" on page 2-8). Th e touchscreen display will revert to the previously used operation mode.
•
Confi rm that the tubing has been calibrated by checking that Calibration Complete
the Program Information
•
If required, prime the pump before operation (for further information see
page 2-12).
To use a program:
1. Select the desired program from the Mode Selection Screen. Th e Program Run Screen will be displayed.
2. Tap START
3. If required, Tap PAUSE
Continuous Mode operation.
NOTE:
•
Tap INFORMATION
•
Individual settings cannot be edited from the Program Run Screen.
Editing a Program
NOTE: If User Management is enabled only users with authorization can create and modify programs (for
further information see
To edit a program:
1. Tap EDIT
multiple programs, tap SCROLL
2. Edit the settings for the selected mode as desired. For instructions on editing individual mode settings see:
•
"Adding a New Program: Continuous
•
"Adding a New Program: Time
•
"Adding a New Program: Volume
•
"Adding a New Program: Analog Input
•
NOTE: Once the individual mode settings have been edited and saved the Program Edit Screen will
be displayed.
3. Tap CONFIRM
3-21
Masterflex SS B/T Washdown Digital Pump Drive with Advanced Connectivity
will display additional pages.
"Loading
Tubing" on page 2-10).
Screen (for further information see
to begin the pump drive operation using the displayed program settings.
or STOP
to view the selected program's settings.
"User
Management" on page 2-8).
located next to the desired program name on the Mode Selection Screen (NOTE: If there are
to display additional pages). Th e Program Edit Screen will be displayed.
Mode" on page 3-17.
to save or CANCEL
during operation. NOTE: Th e pump cannot be paused during
Mode" on page 3-17.
Mode" on page 3-19.
Mode" on page 3-20.
to discard changes and return to the Mode Selection Screen.
"Tube
Calibration" on page 2-13).
"Priming the Pump
"User
is displayed on
Drive" on
Masterflex
Advertisement
Table of Contents
