Table of Contents
Advertisement
Section 2: Basic Setup & Settings
BEFORE STARTING THE DRIVE
CAUTION: Do not block the rear panel of the pump drive. Th e power switch must always
!
be easy to access and the power cord must always be easy to disconnect.
CAUTION: Turn the drive off before removing or installing tubing. Fingers or loose cloth-
ing could get caught in the drive mechanism.
CAUTION: Th e power cord set supplied with your pump drive meets the requirements
!
of the country where you purchased the pump drive. If you use the pump drive in another
country, you must use a power cord set that meets the requirements of that country.
CAUTION: To avoid electrical shock, the power cord protective grounding conductor must
be connected to ground. Not for operation in wet locations as defi ned by EN61010-1.
•
Ensure the pump drive is mounted on a fl at surface.
•
Ensure adequate air fl ow around the pump drive and ensure that the ambient air temperature does not
exceed 104° F (40° C).
•
Tubing should be clean and routed so that bend radii are at a minimum of four (4) times the outside tube
diameter and are as short as possible.
•
Use the appropriate tube diameter for the required fl ow rate and viscosity.
•
Recalibrate tubing regularly to maintain the best fl ow rate accuracy (for further information see
Calibration" on page 2-12).
•
For tubing selection and compatibility go to
•
Unplug the pump drive's power cable from the mains power outlet when cleaning or performing
maintenance on the drive.
SWITCHING ON THE DRIVE
1. Plug in and securely fasten the supplied power cable located at the rear of the drive.
2. Plug the opposite end of the power cable into a mains power outlet.
3. Switch the drive on using the power switch located at the rear of the drive. NOTE: Th e drive takes
approximately two minutes to complete start-up.
NOTE:
•
On the initial start-up the Language Settings Screen will be displayed. A language must be selected before
pump operation (for further information see
•
If User Management is enabled you may be prompted for a username and password (for further
information see
•
Following the initial start-up all subsequent start-ups will revert to the mode of operation screen
previously in use.
•
After 30 minutes of inactivity the B/T will enter sleep mode and the display will turn off . Tapping the
touchscreen will reactivate the drive. To enable (default) or disable the screen saver see
page 2-6.
2-3
Masterflex SS B/T Washdown Digital Pump Drive with Advanced Connectivity
"User
Management" on page 2-8 ).
www.masterfl
ex.com.
"Language
Settings" on page 2-4).
"Tube
"Screen
Saver" on
Masterflex
Advertisement
Table of Contents
