Analog Input - Masterflex MFLX77112-10 Operating Manual

Section 3: Operation
F. LOGOUT: Tap to log out a user. NOTE: Th is option is only available if User Management is enabled in
Settings (for further information see

Analog Input

CAUTION: Power must be turned off before connecting the external analog control cable to pre-
!
vent damage to the drive.
Th e B/T supports and controls analog input using suitable equipment through the pump drive's 31-Pin
female connection port. Analog input can be used in place of, or in addition to, Masterfl exLive™.
See also "31-Pin Electrical
General Preparation:
• Confi rm the correct tubing has been selected and is properly loaded into the pump drive (for further
information see
• Confi rm all fl uids and containers are ready.
• Switch the drive on using the power switch located at the rear of the drive. NOTE: If User Management
is enabled you may be prompted for a username and password (For further information see
Management" on page 2-8). Th e touchscreen display will revert to the previously used operation mode.
• Confi rm that the tubing has been calibrated by checking that Calibration Complete
Analog Input Mode Run Screen (for further information see
• If required, prime the pump before operation (for further information see
page 2-12).
• Confi rm that the pump drive is connected to the appropriate equipment through the drive's 31-Pin
female connection port.
To operate analog input control and monitoring:
1. Tap ANALOG INPUT from the Mode Selection Screen. Th e Analog Input Mode Run Screen will be
displayed.
2. Tap EDIT
3. Tap the desired analog input type from the available list.
4. If using either ANALOG: VOLTAGE or ANALOG: CURRENT:
a. Select the desired current or voltage operating range from the available list.
b. Tap CONFIRM
NOTE:
• Tap STOP
the pump operation. NOTE: If locked, the screen will need to be unlocked before the pump operation
can be stopped.
• See www.masterfl ex.com
3-15 Masterflex SS B/T Washdown Digital Pump Drive with Advanced Connectivity
"User
Connections" on page 4-5.
"Loading Tubing" on page 2-10).
. Th e Analog Input Mode Edit Screen will be displayed.
to save or CANCEL
on the pump drive touchscreen to override the remote control device and immediately stop
for further information on using analog input remote control and monitoring.
Management" on page 2-8).
"Tube
to cancel and return to the previous screen.
is displayed on the
Calibration" on page 2-13).
"Priming the Pump
"User
Drive" on
Masterflex