Table of Contents
Advertisement
Section 3: Operation
hold UNLOCKED
screen. To unlock the screen: Press and hold LOCKED
J. LOGOUT: Tap to log out a user. NOTE: Th is option is only available if User Management is enabled in
Settings (for further information see
K. SETTINGS: Tap to access the Settings Screen (for further information see "Settings" on page 2-4).
Continuous Mode Operation
General Preparation:
•
Confi rm the correct tubing has been selected and is properly loaded into the pump drive (for further
information see
•
Confi rm all fl uids and containers are ready.
•
Switch the drive on using the power switch located at the rear of the drive. NOTE: If User Management
is enabled you may be prompted for a username and password (For further information see
Management" on page 2-8). Th e touchscreen display will revert to the previously used operation mode.
•
Confi rm that the tubing has been calibrated by checking that Calibration Complete
Continuous Mode Run Screen (for further information see
•
If required, prime the pump before operation (for further information see
page 2-12).
To operate the pump in Continuous Mode:
1. Tap CONTINUOUS from the Mode Selection Screen. Th e Continuous Mode Run Screen will be
displayed.
2. If required, Press and hold CUMULATIVE VOLUME RESET
3. Select the desired fl ow rate and fl ow units:
a. Tap FLOW RATE to access the Flow Rate Screen.
b. Tap UNITS to access the Flow Units Screen and select the desired fl ow unit from the available list.
c. Tap CONFIRM
d. Tap FLOW and enter the desired fl ow rate using the onscreen keypad.
e. Tap CONFIRM
Screen.
4. Tap SIZE. Th e Tube Size Screen will be displayed.
a. Select the desired tube size from the list of available options.
b. Tap CONFIRM
Run Screen.
5. If required, tap CALIBRATE to calibrate the pump for the selected tube and fl ow rate.
6. Tap DIRECTION to select either clockwise
7. Tap START
8. Tap STOP
will continue to operate at the displayed fl ow rate and direction until stopped.
3-3
Masterflex SS B/T Washdown Digital Pump Drive with Advanced Connectivity
until the icon changes to LOCKED
"User
"Loading
Tubing" on page 2-10).
to save or CANCEL
to save or CANCEL
to save or CANCEL
. Th e drive will commence operation at the fl ow rate and direction shown.
when the drive operation is no longer required. NOTE: In Continuous Mode the drive
and a red border appears around the
until the icon changes to UNLOCKED
Management" on page 2-8).
"Tube
Calibration" on page 2-13).
to discard changes and return to the Flow Rate Screen.
to discard changes and return to the Continuous Mode
to discard changes and return to the Continuous Mode
or counterclockwise
is displayed on the
"Priming the Pump
to reset the display to zero.
fl ow direction.
.
"User
Drive" on
Masterflex
Advertisement
Table of Contents
