Installation; Installation Procedure; Primary Led Indications - JCM GLOBAL VEGA-RC Twin Series Integration Manual

3 INSTALLATION

This section provides installation and operating
instructions for the VEGA-RC Twin™ Banknote
Recycler unit. The information within this section
contains the following features:

• Installation Procedure

• Connector Pin Assignments
• Preventive Maintenance
• Interface Schematic
• Operational Flowchart
Installation Procedure
Perform the following steps to install an optional
VEGA-RC Twin™ Unit on a VEGA™ Unit body:
1. Place the VEGA-RC Twin™ into position on top
of the VEGA™ Unit as shown in Figure 6. The
four (4) circular guide posts on the bottom of the
VEGA-RC Twin™ Unit should fit directly into
the four (4) circular guide hole receptacles
located on the VEGA™ Unit.
Figure 6 VEGA-RC Twin Positioning
2. Gently press the unit down into the mating hole
receptacles; listen for a click when the two (2)
Latches (See Figure 7 a) lock into place between
the VEGA-RC Twin™ and the VEGA™ Unit
body.
3. Install the VEGA-RC Twin™ Harness Cable
Connector into its VEGA™ Unit mating recepta-
cle to interconnect the units (See Figure 7 b).
P/N 960-000169R_Rev. A {EDP #217859}
VEGA-RC Twin™ Series Banknote Recycler Integration Guide
.
b
a
Figure 7 Latch Button and Harness Location

Primary LED Indications

The LED Color Pattern indications listed in Table 6
occur during various VEGA-RC Twin
ating and error conditions.
Table 6 LED Pattern Color Indications
Description Sequence
Power Supply
Download
Downloading
Download
Complete
Restore
Retrieve
Dispense
Restoring
Retrieving
Dispensing
Initialize
Indications
Communication
with VEGA Unit
Door Open
Error
© 2012, Japan CashMachine Co., Limited
7
Unit oper-
™
Condition
RAM Error
(interval: 0.3sec)
Normal Boot
Download Mode (When short
the Jumper Switch #2)
While downloading from the
host (VEGA or PC)
(interval: 0.5sec)
Software Reset
Stand-by
Normal Operation
(interval: 0.5sec)
Initial Movement
(interval: 0.5sec)
Door open
(interval: 0.5sec)
Banknote jam occur
(interval: 0.5sec)
Waiting for communication
from a VEGA Unit
(interval: 0.5sec)
While in Normal Operation
(interval: 0.5sec)
Error occurs (Machine Lock)