Table of Contents
Advertisement
7. MAIN MENU
To enter the main menu, press MENU on your remote control. In the main menu you can manage channels,
timers, speci c receiver settings, get access to multimedia and receive useful information about the receiver,
programmes, operator messages, etc.
The main menu contains the following chapters: Channel, Multimedia, Installation, Settings and CAS.
By entering the menu and pressing MENU or buttons, you will level up within the menu or close it.
By pressing the
button you will exit the menu.
7.1 Channel
Use t u to access the menu Channel, which includes the following submenus: Electronic Program Guide,
Channel manager, Favorite manager and Timers. Use p q to select the submenu and press OK.
7.1.1 Channel manager
To edit your channel list Delete, Lock, Move or Rename, select Channel manager and press OK. You will be
asked to enter a PIN code to continue. (default PIN 0000). Use p q to select channel you like to edit. Use
the button to return to the previous step. Press
Deleting of TV / Radio programmes
1. By using p q select channel you like to delete.
2. Press RED Delete button to mark this channel.
3. If you like to delete more channels, repeat these steps.
4. To switch from TV to Radio list. Press TV/R Button.
5. Press or
to con rm or cancel your changes and exit the deleting mode.
Locking TV programmes
You can lock selected programmes for restricted view protected with PIN.
1. By using p q select channel you like to protect.
2. Press GREEN Lock button to mark this channel and press again to unlock.
3. If you like to lock more channels, repeat these steps.
4. To switch from TV to Radio list. Press TV/R Button.
5. Press or
to con rm or cancel your changes.
To view the locked programme, you need to enter a PIN code. We recommend you to change the default PIN
code and enter a new PIN code. Refer to chapter 7.2.3 for more details.
Moving TV programmes
This receiver comes with pre-installed channel list and channel list from Operator.
These channels are automatic sorted by LCN mechnisch. (Logic Channel Numbers).
Channels can be sorted if you like but do not use numbers which are already occupied.
1. By using p q select channel you like to move.
2. Press YELLOW Move button to mark this channel.
3. Banner will pop-up to enter new LCN channel number.
4. By using t u select a digit which will light-up and enter number.
5. Con rm with OK to program this new channel number.
6. If you like to move more channels, repeat these steps.
7. To switch from TV to Radio list. Press TV/R Button.
8. Press or
to con rm or cancel your changes.
Pre-installed range = 1 to 99 Operator range = 100 to up to 1799
to exit the menu and to go back to the viewing mode.
Other range = 1800 and up.
17
Advertisement
Table of Contents
