Sungrow SG25CX-P2 User Manual page 89

User Manual
Designation
No.
7 Power curve
Navigation bar
8
table 7-4 Description of Inverter State
State
Run
Stop
Press to Shut
Down
Standby
Initial standby
Starting up
Warn run
Derating
running
Dispatch
Running
Shut down
table 7-5 Description of PID State
State
PID recovery
running
PID abnormity
If the inverter is running abnormally, the alarm or fault icon
right corner of the inverter icon in power flow chart. The user can tap this icon to enter the
alarm or fault interface to view detailed information and corrective measures.
Description
Curve showing change of power between 5 am and 23 pm
every day
(Each point on the curve represents the percentage of
present inverter power to rated power)
Including "Home", "Run Information", "Records", and
"More"
Description
After being energized, inverter tracks the PV arrays' maximum power
point (MPP) and converts the DC power into AC power. This is the
normal operation mode.
Inverter is stopped.
Inverter will stop operation by tapping "Stop" via app. In this way,
inverter internal DSP stops. Restart the inverter via app if needed.
Inverter enters standby mode when DC side input is insufficient. In this
mode inverter will wait within the standby duration.
The inverter is in the initial power-on standby state.
The inverter is initializing and synchronizing with the grid.
Warning information is detected.
The inverter derates actively due to environmental factors such as
temperature or altitude
The inverter runs according to the scheduling instructions received from
the monitoring background
If a fault occurs, inverter will automatically stop operation, and the AC
relay acts. The fault information will be displayed on the app. Once the
fault is removed in recovery time, inverter will automatically resume
running.
Description
The inverters perform PID recovery actively.
It is detected that the ISO impedance is abnormal or the PID cannot
work normally after the PID function is enabled.
7 iSolarCloud App
will be displayed in the lower
79