Wall-Mounted Installation - Sungrow SG25CX-P2 User Manual

User Manual
- - End

4.5.2 Wall-Mounted Installation

Tool preparation
Name
Maker
Level
Hammer drill
Wrench
Material preparation
Name
Expansion
bolt
Step 1 Place the mounting-bracket at the installation place, adjust the angle with a level, and mark
the location of the drilled holes.
Step 2 Drill holes with a hammer drill. Clean up the holes, stuff the expansion bolts into the holes,
and fix them with a rubber mallet. Use a wrench to tighten the nut to fix the end of the bolt,
take off the nut, spring washer and flat washer for spare.
After removing the nut, spring washer, and flat washer, level the front of the expan-
sion tube with the wall. Otherwise, the mounting brackets will not stay steady on
the wall.
Specification
—
-
Bit: φ12
Inner diameter: 16mm
Quantity
2
Specification Source
M10 Not included in the delivery
scope
4 Mechanical Mounting
27