Yamaha RX-V2600 Owner's Manual page 87

Use this menu to adjust the sound parameters.
1 Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
Press A / V on the remote control to select
Manual Setup and then press _>.
Press A / V on the remote control to select
Sound and then press L>.
• LFE Level (Low-frequency effect level)
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
snbwoofer or headphones. The LFE channel carries
low-frequency special effects which are only added to
certain scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
To access these parameters, select:
Manual Setup > Sound > LFE Level >
Control range: _0.0 to 0.0 dB
Control step: 1 dB
Speaker (Speaker low-frequency effect level)
Select to adjust the speaker LFE level.
Headphone (Headphone low-frequency effect
level)
Select to adjust the headphone LFE level.
Depending on the settings of LFELevel, some signals may not be
output al the SUBWOOFER jack.
Select the desired parameters and then press
to access and adjust.
83