Yamaha RX-V2600 Owner's Manual page 39

Press V to select Start and then press
ENTER.
Loud test tones are outpnt from each speaker and
"Measuring" appears during the AUTO SETUP
procedure.
You can confirm the resnlts of each analysis.
If you set Setup Type to "Auto"
Tile results are displayed after all items have been
analyzed.
,Iql",l-'l-'ilq +
• To stop the AUTO SETUP procedure, press one of the
cursor buttons (A / V / <51/ [:::>) or ENTER. In the pause
mode, press A to retry the procedure. <:1 to cancel AUTO
SETUP.
• If an error message appears during testing, reli:r to
TROUBLESHOOTING on page 126. and after carrying
out the remedy, retry the AUTO SETUP procedure.
• Press V and select Setup to set the measured values.
• Press A and select Retry to retry the AUTO SETUP
procedure.
• Press C:>and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see
TROUBLESHOOTING on page 126.
• Press <1 and select Exit to exit from the AUTO SETUP
procedure. If you select Exit. "Don't Setup'?" appears on
the screen. To set the measured wdues and exit. select Yes.
To cancel the settings and exit. select No.
If you set Setup Type to "Step"
The results are disphtyed individually after each analysis.
• Press V and select Next to start measurement of the next
menu item.
• Press _ and select Retry to retry the AUTO SETUP
procedure.
• Press C:>and select Detail to view information about
measurement results and
waruing
messages. For
nlore
details about warning messages, see
TROUBLESHOOTING on page 126.
• Press <1 and select Exit to exit l?om the AUTO SETUP
procedure. If you select Exit. "Don't Setup'?" appears on
the screen. To set the measured wdues and exit. select Yes.
To cancel the settings and exit. select No.
35