Yamaha RX-V2600 Owner's Manual page 115

MACRO operations
Macro buttons
(U.S.A. model)
:I:/j_[OJI_[I..ro]_TII:fO]Uffff__|II]:/.'[_
• Programming MACRO operations
You can program your ov,,n macro and use tile MACRO
feature to transmit several remote control commands in
sequence at the press of a button. Be sure to set up remote
control codes or perform learning operations before
progrannning the macro. We do not recommend
programming continuous operations such as volume
control in a macro.
MACRO ON/OFF MACRO
1 Set MACRO ON/OFF to ON.
2
Press a macro button.
• When you haxe finished using the MACRO lbature, set
MACRO ON/OFF to OFF.
• While the remote is carrying out a MACRO program, it will not
accept any other btltton's fm/ction until the macro operation is
complete (the transmission indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
• The def:mlt macro is not cleared when a new macro is
programmed lot a button. The def:mlt macro can be used a_ain
when the progranlmed macro is cleared.
• It is not possible to add a new signal (macro step) to the delault
macro. Programming a macro changes all macro contents.
Set AMP/SOURCE/TV to AMP or SOURCE.
Press MACRO using a ballpoint pen or
similar object.
"MCR ?" appears in the display windov<
If you do not complele each of the lollowing steps wilhin 30
seconds, the macro programnfing mode will be
aulonmtically canceled. In this case, press MACRO again.
Press the macro button you want to use to
operate the macro.
The macro button nanae (ex. M;DVD) and the
selected component name (ex. DVD) appear
alternately in the disphty window.
g D
(U.S.A. model)
,aoto
AGAIN appears in the display window if you press a button
olher than a macro bullion.
111