Yamaha RX-V2600 Owner's Manual page 37

,lll'l.,l-'l-.'illl+
For best results, make sure the room is as quiet as possible
during the AUTO SETUP procedure (YPAO). If there is
too much ambient noise, the results may not be
satisfactory.
_.,#._
• You can run AUTO SETUP using tile systenl menu that appears
in the GUI or in the front panel display. This manual uses tile
GUI illustrations Io explain tilt AUTO SETUP procedure.
• If an error occurs during the AUTO SETUP procedure and an
error message appears in tilt front panel display, see pages 126
and 127 lot a conlplete list of error nlessages and proper
remedies.
• If your subwoolcr
can at]illS[
the output volunle and tile
crossover h'equency, set tile volume to about half' way (or
slighlly less) and set tile crossover frequency to the nlaximunl.
CROSSOVER
HIgH CUT VOLOr_l E
rain _IAX
Subwoofer
1
2
Switch on this unit and video monitor.
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
The top display appears.
+++V+ + %
++
3 Press/_ / V repeatedly to select Auto Setup
and then press _>.
++
(U.S.A. model)
4
Press/_ / V repeatedly to select Setup Menu
and then press C>.
33