Yamaha RX-V2600 Owner's Manual page 20

II_'tfll'l'_ql['tl'_
Remove approximately 10 mm (3/8 in) of
insulation from each of the speaker cables.
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
Speaker terminal wrench
Twist the exposed wires of the cable together
to prevent short circuits.
Red: positive (+)
Black: negative (-)
3 Loosen the knob using the supplied speaker
terminal wrench.
Speaker terminal wrench
6 Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
Red: positive (+)
Black: negative (-)
4
Insert one bare wire into the hole on the side
of each terminal.
/
Red: positive (+)
Black: negative (-)
16