Yamaha RX-V2600 Owner's Manual page 105

This unit has additional menus that are displayed in the front panel display. The ADVANCED SETUP menu offers
additional operations to adjust and customize the way this unit operates. Change the initial settings (indicated in hold
nnder each parameter) to reflect the needs of your listenim enviromnent.
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to set
this unit, Zone 2 and Zone 3 to the standby
mode.
f_S_rER
Press and hold STRAIGHT (EFFECT) on the
front panel and then press MASTER ON/OFF
inward to the ON position to turn on the
power of this unit.
MASTE_
STRAEGHT
E#_ oN
Press STRAIGHT (EFFECT) on the front
panel repeatedly to change the setting.
STRAIGHT
= ,
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and set this unit, Zone 2 and
Zone 3 to the standby mode.
r_ASTER
The new setting is activated next time you press
MASTER ON/OFF inward to the ON position to turn on the
power of this unit, Zone 2 and Zone 3.
Rotate the PROGRAM selector on the front
panel to select the parameter you want to
adjust.
The name of the selected parameter appears in the
front panel display.
See page 101 and 102 for a complete list of available
parameters.
PROGRAM
O
i::i [ :,.)i::i f .i2 E [:, !ii; i i:i i.jF::'
,:::" _:::, "r _,,.i E:: ...... i::i0 M r H
Name of the selected parameter Current setting
• The control buttons on the remote control and VOLUME as
well as the other control buttons on the front panel except
MASTER ON/OFF, STRAIGHT (EFFECT) and the
PROGRAM selector are ineffective while you are using the
ADVANCED SETUP menu.
• Zone 2, Zone 3 and the speaker relay are all turned oil and all
audio and video output is muted while you are using the
ADVANCE[) SETUP menu.
• The ADVANCE[) SETUP menu is only available in the front
panel display.
• Speaker impedance :!!;F::' iMF',,
Use to set the inlpechmce of this unit so that it matches that
of your speakers.
Choices: 6f_MIN, 8f2MIN
• Select 6f_MIN for speakers with 6 ohms or higher.
• Select 8f_MIN for speakers with 8 ohms or higher.
• User preset F:i:;;:I!!!::!!;ET
Use to reset all the parameters of this unit to the initial
factory settings with the exception of System Memory and
AUTO SETUP settings.
Choices: CANCEl_, RESET
• Select CANCEL if you do not want to reset the
parameters of this unit.
• Select RESET to reset the parameters of this unit.
• This setting does not afli:ct the ADVANCED SETUP menu
item parameters.
• The initial lactory settings are activated next time you turn on
the power of this unit.
101