Yamaha RX-V2600 Owner's Manual page 83

Use the remote control to access and adjust each
parameter. (Speaker set is used in the follovdng exainple
to change parameter settings.)
Manual Setup > Basic > Speaker Set >
Press A / V repeatedly to select the
parameter you want to adjust.
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
Tile top display appears.
4
Press ENTER or E> and then press A / V
repeatedly to change the setting of the item
you want to adjust.
5 Press EXIT.
If you want to continue adjusting parameter settings, press
ENTER to return to the previously selected menu itmn.
Press A / V repeatedly to select a menu and
then press E> to enter the selected menu.
• The available parameters may be displayed on more than one
page of the GUI display. To scroll through pages, press A / V.
• You cannot change paraineter values when Memory Guard is
set to "On'. If you want to change the paralneter values, set
Memory Guard to "Ofl" (see page 98).
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cable is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
79