Yamaha RX-V2600 Owner's Manual page 14

This section describes the Erection ofeach
control on the
Zone 2/Zone 3 remote control used to control Zone 2 or
Zone 3.
The XM Satellite Radio controls (XM. DISPLAY. PRESET.
ALL. CAT.. numeric buttons. NUMBER. cursor buttons
A / V / <:_ / 12> and ENT) are only applicable to the U.S.A. model
and are operational only when XM is selected as the input source.
For details, see "Zone 2/Zone 3 remote control Erections" on
page 55.
A/B/e/D/E
.... ,,,,_ 5
........ ,,_
(U.S.A. model)
@ Input selector buttons
Select the desired input source of Zone 2 or Zone 3 and
change the control area.
PRESET +/-
Selects tile preset station nnlnber (1 to 8) when TUNER is
selected as the input source or Zone 2 or Zone 3.
@
AIBIC/D/E
Selects the preset station group (A to E) "a, h en TUNER is
selected as the input source or Zone 2 or Zone 3.
@ IDI/ID2 switch
S'a, itches the remote control ID between IDI and ID2
(see page 106).
_5 POWER
Turns on Zone 2 or Zone 3.
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
@
STANDBY
Sets Zone 2 or Zone 3 to tile standby mode.
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
@
VOLUME +/-
Increases or decreases the volume level or Zone 2 or
Zone 3.
@
MUTE
Mutes the sound of Zone 2 or Zone 3.
Press again to restore the audio outpnt to the previous
volume level.
@
ZONE 2/ZONE 3 switch
Sw,itches between tile operation mode of Zone 2 and that
of Zone 3.
10