Yamaha RX-V2600 Owner's Manual page 34

• Connecting the AC power cable
Plug the supplied AC power cable into the AC inlet after
all other connections are complete and then plug the AC
power cable to an AC wall outlet.
When all connections are complete, turn on the power of
this unit.
2,3
(U.S.A. model)
rs,7_, IIJtf[I]lq
Use the supplied AC cable. Do not use other AC power cables as
doing so may result in fire hazard or eleclrical shock.
(U.S.A. model)
• AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected
components. Connect the AC power cables of your other
components to these 2 outlets. Power to these 2 outlets is
supplied when the main room, Zone 2 or Zone 3 is turned
on. However, power to these 2 outlets is cut off when the
main room, Zone 2 and Zone 3 are turned off or when
MASTER ON/OFF on the front panel is pressed and
released outward to the OFF position. The maximum
power or the total power consumption of the components
that can be connected to these 2 outlets is 100 W.
Memory back-up
Tire nremory back-up circuit prevents tire stored data
from being lost. However, the stored data will be lost
in case the power cord is disconnected from the AC
wall outlet for more than one week.
1,4
Press MASTER ON/OFF on the front panel
inward to the ON position to turn on the
power of this unit.
• Only this unit is tnrned on.
• Zone 2 and Zone 3 are set to the standby mode.
I_ASVE_
Press MAIN ZONE ON/OFF on the front panel
(or STANDBY on the remote control) to set
this unit to the standby mode.
Front panel
or
Remote control
30