Yamaha RX-V2600 Owner's Manual page 126

IIIit'i q:lA1"T'lilqqlh'l •
Problem
The sound suddenly
goes off.
Only the speaker on
one side can be
heard.
Only the center
speaker outputs
substantial sound.
No sound from the
effect speakers
No sound from the
center speaker
No sound from the
surround speakers
No sound from the
surround back
speakers
No sound from the
subwoofer
Cause Remedy
The protection circuitry has been activated
because of a shorl circuit, etc.
Check that tile impedance selector setting is correct.
Check the speaker wires are not touching each other
and then turn this unit back on.
The sleep timer has turned the unit off. Turn on the power, and play the source again.
The sound is muted. Press MUTE to cancel a mute.
Incorrect cable connections.
Incorrect bahmce settings in the GUI
[llenu.
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channeh and the
flont and stlrround speakers output effect
sounds.
Connect the cables properly. If the problem persists,
the cables may be defective.
A([just the Speaker Level settings.
Tile sound field programs are turned off. Prc.ss STRAIGHT (EFFECT) to turn them on.
You arc, using a source or progrmn Try another sound field program.
combination that does not output sound
flom all channels.
The output level of Ihe center speaker is Raise the level of tile center speaker.
set to minilnum.
Center is set to None in Speaker Set. Select the appropriate setting for the center speaker.
One of the HiFi DSP programs (except %r Try another sound field program.
7cb Stereo) has been selected.
The output level of the surround speakers Raise the output level of tile surround speakers.
is set to minimum.
Surround is set to None ill Speaker Set.
A monaural or stereo source is being
played with STRAIGHT.
Presence speakers are selected.
Select the appropriate setting for tile surround left and
right speakers.
Press STRAIGHT (EFFECT) to turn on the sound
fields.
Select Surround Back in PR/SB Priority.
Surround is set to None ill Speaker Set.
Surround Back is set to None ill Speaker
Set.
lfthe surround left and right speakers are set to None,
surround back speakers arc,automatically set to None.
Select the appropriate setting for tile surround left and
right speakers.
Select Small x I, Small x2, Large x I or Large x2.
Bass Out is set to Front when a Dolby
Digital or DTS signal is being played.
Bass Out is set to SWFR or Front when a
2-channel source is being played.
The source does not contain low bass
signals.
Select SWFR or Both.
Select Both.
See
page
31
39
2O
93
43
37
93
90
37
93
90
86
90
90
92
92
122