Yamaha RX-V2600 Owner's Manual page 130

IIIiPPl:lAI-T'lilqqlffl •
• AUTO SETUP
Before AUTO SETUP
See
Error message Cause Remedy
page
Connecl Ihe supplied oplimizer microphone to the 52
Connect MIC! Optimizer microphone is not connecled. OPTIMIZER MIC jack on the front panel.
Unplug Phones!
Headphones are connected. Unplug the headphones.
No Setup Menu! No setup menu items have been selected. Select at least one setup menu item.
Memory Guard! This setting is protected. Remove the protection setting for AUTO SETUP. 98
During AUTO SETUP
See
Error message Cause Remedy
page
E01:No Front SP
Front L/R channel signal/s) is (are) not
detected.
Select the front speakers by pressing SPEAKER A or
B on the fiont panel (or by setting AMP/SOURCE/
TV to AMP and then pressing SPEAKER A or B on
the remote control).
Check the front L/R speaker connections. 15
EO2:No Surr. SP A surround channel signal ix not detected. Check the surround speaker connections. 15
EOa:No PRNS SP A presence channel signal is not detected. Check the presence speaker connections. 15
EO4:SBR->SBL Only righl sunound back channel signal ix Connecl the surround back speaker to Ihe LEFT
detected. SURROUND BACK SPEAKERS terminal if you 15
only ha',e one surround back speaker.
Try running AUTO SETUP in a quiet environment.
E05:Noisy
Background noise is too loud.
Turn off noisy electric equipment like air conditioners
or move them away from the optimizer microphone.
Surround back speaker(s) is (are)
Connecl surround speakers when you use (a/
connected, Ihough surround L_ speakers surround back speaker/s). 15
are [IOI.
The optimizer microphone was unplugged
during the AUTO SETUP procedure.
Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the fiont panel.
Check the microphone setting.
Check the speaker connections and placement.
E06:Check Surr.
E07:No MIC
E08:No Signal
E09: User Cancel
E10:Internal Err
The optimizer microphone does not detect
test tones.
The AUTO SETUP procedure was Run AUTO SETUP a_,ain.
cancelled due to user aclivity.
An internal error occurred. Run AUTO SETUP again.
32
32
15
32
32
126