Yamaha RX-V2600 Owner's Manual page 32

|'_'tfll'l_ql['h'_
• Connecting an external amplifier
If you want to increase the power output to the speakers,
or want to use another amplifier, connect an external
amplifier to the PRE OUT jacks as tbllows.
• When audio pin plugs are connected to the PRE OUT jacks tor
output to an external amplifier, it is not necessary to use the
corresponding SPEAKERS terminals. Set the volume of the
external amplifier connected to this unit to the maximunl.
• The signal output at the FRONT PRE OUT and CENTER PRE
OUT jacks are at'ti:cted by the TONE CONTROL settings.
• If SPEAKERS A is turned off and SPEAKERS B is set to Zone
B (see page 95), signals will only be output at the FRONT PRE
OUT jacks.
@ FRONT PRE OUT jacks
Front channel line output jacks.
@ SURROUND PRE OUT jacks
Surround channel line output jacks.
@ SUBWOOFER PRE OUT jack
Connect a subwoofer with built-in amplifier, such as the
YAMAHA Active Servo Processing Subwoofer System,
to this jack.
@ SURROUND BACK/PRESENCE PRE OUT
jacks
Surround hack or presence channel line output jacks. If
you only connect one external amplifier t_r the surround
back channel, connect it to the left (L) jack.
@ CENTER PRE OUT jack
Center channel line output jack.
• Each PRE OUT jack outputs the same channel signal as the
corresponding speaker ternfinals. However. when both surround
back and presence speakers are setup in this unit. the signals
output at SURROUND BACK/PRESENCE PRE OUT jacks
may not correspond to the correct speakers.
• A@lst the wflume level of the subwoofer with the control on
the subwoofcr.
• S()me signals may not be output at the SUBWOOFER PRE
OUT.jack depending on the Speaker Set settings (see page 90).
28