Yamaha RX-V2600 Owner's Manual page 129

rfp_li:l_=h'li_,jqiff_J
• Remote control
See
Problem Cause Remedy
page
The remote control Wrong distance or angh:. The remote control will fimction within a maximum
does not work or range of 6 m (20 fl/and no more than 30 degrees off 5
function properly,
axis fiom the front panel.
Direct sunlight or lighting (from an Reposition this unit.
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries arc. weak. Replace all batteries. 4
AMP/SOURCE/TV is set incorrectly.
The remote control code was not correctly
set. 105
Set AMP/SOURCE/TV correctly.
When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PHONO
arc& set it to the TV position.
Set the remote control code correctly using
"LIST OF REMOTE CONTROL CODES" at the end
of this manual.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manuah
IO5
The library code of the remote control and Match the remote control ID of this unit with the
the remote control ID of this unit do not corresponding remote control library code. 102. 105
match.
Even if Ibe remote control code is Program the necessa W fimctions independently into
correctly set, there ar,: some models that the programmable buttons using the Learn feature. 107
do not respond to the remote control.
Tbe batteries do not last long and get Using alkaline batteries is strongly recommended.
quickly exhausted.
The remote control Tbe batteries of this remote control and/or Replace the batteries. 4
does not learn new the other remote control are too weak.
functions.
Tbe dislance bLqween tbe I\x, roremote Place Ihe remole controls al Ihe proper dislance. 107
controls is too much or too little.
The signal coding or modulation of the Learning is not possible.
other remote control is not compatible
with this remote control.
Memory capacity is l]dh Delete other unnecessary functions to make room for
112
the new functions.
125