Yamaha RX-V2600 Owner's Manual page 107

In addition to controlling this unit, the remote control can also operate other audio and video components made by
YAMAHA and other mannfactnrers. To control these other components, yon nmst set up the remote control with the
appropriate remote control codes. This remote control also has a learn feature which allows the remote to acquire
functions from other remote controls equipped with an infrared remote control transmitter.
!llii!!iiii!!! i!tiiiiiiii! iiiiiiiiii!llii liiii! l ! !!i i i t
• Controlling this unit
The shaded areas below can be used to control this unit
alter setting AMP/SOURCE/TV to AMP to activate the
AMP mode.
Display
window --
AMP/SOURCE/
TV-
Set to AMP to
operate this unit.
The buttons inside
the dotted lines
control this unit in
-- any mode (POWER,
STANDBY,
SLEEP, AUD[O
SEL, the input
selector buttons,
VOLUME +1 ,
MUTE,
STRAIGHT
(EFFECT) and
PURE DIRECT).
(U.S.A. model)
• Controlling other components
The shaded areas below can be used to control other
components. Each button has a different fnnction
depending on the selected components. Select the
component you want to control by pressing an input
selector button or SELECT A / V. The name of the
selected component appears in the display window.
The A and input
selector buttons
switch the function
of Ihe component
control area below.
' Use the A button to
control other
componenl s
regardless of whether
they arc connected to
this unit.
Factory setting:
A...Tape deck
Display
window "
Component
control area --
You can control up
to 14 different
components by
setting appropriate
renlote control
codes
(see page 105).
iC) C) C) C)
SELECT A / V
swilches control Io
another component
without changing
the input source on
this unit.
AMP/
TV
Set to
SOURCE to
operate the
component
selected with
an input
selector
button.
Set to TV to
operate the
television
(you must set
the remote
control code
in DTV or
PHONO).
(U.S.A. model)
• Controlling optional components (OPTN area)
OPTN is :m additional component control area that can be programmed with remote control fnnctions independently
from any input source. This area is useful for programming commands that are to be used only as :t part of a macro
function or for components that do not have a valid remote control code.
To select the OPTN control area, press V repeatedly until OPTN appears in the display window.
You cannot sel a remole control code lot this area. See page 107 to program bullons operated within this component conlrol area.
103