Setting The Reel Speed - Toro Reelmaster 5610-D Operator's Manual

Adjusting the Lift-Arm Turnaround Position (continued)
3. Loosen the jam nut that secures lift-arm switch
to the switch plate
4. Adjust the lift-arm switch as follows:
• To increase the lift-arm turnaround height,
move the switch down.
• To decrease the lift-arm turnaround height,
move the switch up.
Maintain an air gap of 1.0 to 2.5 mm (0.040 to 0.100 inches) between the switch and
the lift-arm trigger. The LED light on the switch verifies proper function of the switch.
5. Torque the jam nuts to 20 +/- 2 N∙m (15 +/- 1.5 ft-lb).
Do not overtorque the jam nuts; otherwise, you may damage the sensor.

Setting the Reel Speed

It is important that proper reel speeds are used for your mowing application.
• Reel speeds that are too slow may result in a wave pattern in the turf, also known
as clip marks, marcelling, or bobbing. If this is observed, try increasing the reel
speeds or reducing the mowing speed.
• Reel speeds that are too fast may result in turf damage and/or premature wear of
the reels, bedknives, and other mechanical components.
To adjust the reel speed manually, complete the following:
1. In Machine Settings, enter the blade count, mow speed, and HOC to calculate the
proper reel speed.
2. If further adjustments are required, in Machine Settings , scroll down to Front Reel
Speed, Rear Reel Speed, or both.
3464-486A
.
IMPORTANT
IMPORTANT
IMPORTANT
Page 5–29
G439054
Operation: During Operation