Filling The Fuel Tank; Adjusting The Clip Rate; Adjusting The Reel Speed - Toro Greensmaster 1021 Operator's Manual

Filling the Fuel Tank

1. Clean around the fuel-tank cap and remove the
cap from the tank
to the bottom of the tank-neck opening; refer to
your engine Operator's Manual.
Important:
Do not overfill the tank with fuel.
Figure 12
1. Fuel-tank cap
2. Install the fuel-tank cap and wipe up any spilled
fuel.
(Figure 12). Fill the fuel tank

Adjusting the Clip Rate

The clip rate is determined by the following machine
settings:
•
Reel speed: You can adjust the reel speed to a
high or low setting; refer to
Speed (page
•
Reel-drive-pulley position: You can set the
reel-drive pulleys in 2 positions; refer to your
cutting unit Operator's Manual.
To determine the reel speed and reel-drive-pulley
position for the appropriate clip, refer to the following
table:
Clip Rate
Reel Belt
Speed Position
Low Low
Low High
High Low
g265976
High High

Adjusting the Reel Speed

Use the reel-speed-control knob
the reel speed.
•
High reel speed: Rotate the knob so that the "H"
on the knob is directed toward the front of the
machine.
•
Low reel speed: Rotate the knob so that the "L"
on the knob is directed toward the front of the
machine.
13
Adjusting the Reel
13).
Cutting Unit
8-blade 11-blade
7.3 mm 5.3 mm
(0.286 inch) (0.208 inch)
8.7 mm 4.4 mm
(0.241 inch) (0.175 inch)
5.9 mm 4.3 mm
(0.233 inch) (0.169 inch)
5.0 mm 3.6 mm
(0.196 inch) (0.142 inch)
(Figure
14-blade
4.2 mm
(0.164 inch)
3.5 mm
(0.137 inch)
3.4 mm
(0.133 inch)
2.8 mm
(0.112 inch)
13) to adjust