Screw Hook Installation - Chore-Time H2 PLUS Installation & Operator's Instruction Manual

4. Route the cable through the
Winch Drum Relief located
near the bottom of the drum.
Tighten the set screw to anchor
the cable to the drum. See
Figure 10.
5. Turn the winch drum one full revolution.
Guide the cable against the flange at the
bottom of the winch drum. The cable must
not wrap over itself on the drum, but
should be wrapped as close as possible to
each previous wrap. See Figure 11.

Screw Hook Installation

The recommended distance between
the drops for the Model H2 Plus is 8'
[2.4 m] on center. Do not exceed 10'
[3 m] spacing on drop lines.
If the distance raised is greater than
the distance between the drop
spacings, offset the hooks 3" [7.6 cm]
to each side of the line to prevent the
cable clamps from catching the
pulleys. See Figure 12.
Screw the hook into the truss the full
length of the threads to prevent
bending.
The openings of the screw
hooks must be pointed
away from the direction
of travel when the Power
Winch raises the feeder
line.
See Figure 13.
Figure 10. Attaching the cable to the Power Winch
Main Winch Cable
3" [7.6 cm]
Offset
Distance Feeder
is to be Raised
Screw Hook
opening facing
opposite direction
of travel
3/16" Main
Winch Cable
Figure 13. Screw Hook Installation
Model H2™ Plus Feeding Systems
Drum Direction
of Rotation
Figure 11. Power Winch Drum Rotation
3/16" [5 mm]
Screw Hook or Ceiling Hook Location
Distance
of Cable
Travel
Figure 12. Drop line off set detail
3/32" Drop Cable
1523-83 4/2002
3/32" [2 mm]
Drop Cable
1523-82 4/2002
Winch End
(Direction of Travel)
1523-81 4/2002
11