Mitsubishi Electric GOT 1000 User Manual page 82

6.5 Installation Procedure
6.5.1 Installation procedure
The GOT is designed to be embedded into a panel.
Mount the GOT by following the procedure below.
1 Installing the packing
Install packing to the packing installation groove on
the back panel of the GOT.
• For GT105
While referring to the cross sectional view of the
packing shown right, push the thinner side into the
packing groove. (Right drawing is the example of
lateral format.)
6 - 10 6.5 Installation Procedure
6.5.1 Installation procedure
Cautions on the installation panel
Refer to "Section 6.2 Panel Cutting Dimensions" for the panel cutting dimensions
and panel thickness.
Make sure that the panel surface is free from warpage, flaws and irregularities.
Warpage, flaws and irregularities may disable the waterproof effect.
Select proper panel thickness under consideration of the panel strength.
(For example, the panel strength may be insufficient depending on the panel
material and dimensions even if the panel thickness is acceptable. Insufficient panel
strength may cause warpage depending on the installation positions of the GOT and
other equipment.)
Packing
Magnified
illustration
Packing
Magnified
illustration
Packing
Packing installation groove
Packing cross sectional view
Packing
Packing installation groove
Inserting direction