Mitsubishi Electric GOT 1000 User Manual page 205

15.3.5 Display
1 Outline until the start
The following explains the outline until the operation screen of MELSEC-FX list editor is displayed.
Starting from the
utility
Display the utility.
After the utility is displayed, touch
[Debug] [MELSEC-FX List editor]
from the main menu.
For how to display the utility, refer
to the user's manual of the GOT to
be used.
When no keyword
is registered in the
connected FX PLC
The MELSEC-FX list editor is started.
(1) How to display the utility
(2) If the project data has not been downloaded
Start
Turn on the power to the GOT.
End
For how to display the utility, refer to the following.
Section 9.2 Utility Display
The MELSEC-FX list editor can be started from the utility even if the project data
has not been downloaded to the GOT.
15.3 FX List Editor (For GT104[ ], GT105[ ] only)
Starting from the special function
switch (MELSEC-FX list editor)
set in the project data
Touch the special function switch.
Refer to the following manual for
how to set the special function switch.
GT Designer2 Version
Screen Design Manual
GT Designer3 Version1
Screen Design Manual (Functions)
When a keyword is
registered in the
connected FX PLC
Enter the keyword.
Subsection 15.3.16 Keywords
15.3.5 Display
9
10
11
12
13
14
15
16
15 - 18