Mitsubishi Electric GOT 1000 User Manual page 122

8.8.2 Applicable serial multi-drop connection unit
The following serial multi-drop connection unit is applicable.
Model
GT01-RS4-M
8.8.3 Part name
1)
2)
10)
No.
1) Installation hole for the main unit
2) LED
3) Terminating resistor selector
4) Connector for PLC communication
Connector selection switch for PLC
5)
communication
6) USB port
7) Connector for PLC communication
8) Protective cover
Terminal block for the serial multi-drop
9)
communication
10) Power supply connector
11) Slider for installing the DIN rail
Mode selection switch
12)
(Slide switch)
8 - 30 8.8 Serial Multi-Drop Connection Unit
8.8.2 Applicable serial multi-drop connection unit
• Protective cover is installed
2- 4.5
57
65
12)
11)
Name
Installation hole
POWER Lit in green when the power is properly supplied.
SD Lit in green when the data is being sent to PLC.
RD Lit in green when the data is being received from PLC.
ERROR Lit or blinking depending on the status.
Can be selected among 110 , OPEN and 330
(set to "OPEN" by default)
D-sub 9-pin (male) For RS-232 connection
Switch for selecting RS-422 or RS-232 (set to "RS-422" by default)
For connecting to a personal computer (for changing the
communication driver)
D-sub 9-pin (female) For RS-422 connection
Protect unused D-sub connector, USB port and switches.
Terminal block 5-pin (with a protective cover) M3 Tightening torque
0.5 to 0.6N.m
24VDC power supply connector insertion point (A dedicated cable is
included.)
Do not operate. (Set to right by default. When set to left, the module
does not operate normally.)
Contents
For GOT multi-drop connection
• Protective cover is removed
4)
3)
7)
9)
Specifications
5)
8)
6)
