Mitsubishi Electric GOT 1000 User Manual page 44

3. SPECIFICATIONS
3.1 General Specifications
Item
Display section 0 to 50
Operating
ambient
Other than
temperature
display section
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*2
Operating altitude
Installation location
Overvoltage category
*4
Pollution degree
Cooling method
*5
Grounding
*1 : The wet bulb temperature is 39
*2 : Do not use or store the GOT under pressures higher than the atmospheric pressure of altitude 0m (0ft.). Failure
*3 : This indicates the section of the power supply to which the equipment is assumed to be connected between the
*4 : This index indicates the degree to which conductive pollution is generated in the environment where the
*5:
3 - 1 3.1 General Specifications
0 to 55
-20 to 60
*1
10 to 90% RH, non-condensing
*1
10 to 90% RH, non-condensing
Conforms to
JIS B3502
and
IEC61131-2
Conforms to JIS B3502, IEC 61131-2 (147 m/s
each in the X, Y, and Z directions)
Must be free of lamp black, corrosive gas, flammable gas, or excessive amount of
electro conductive dust particles and must be no direct sunlight. (Same as for saving)
2000 m (6562 ft) max.
Inside control panel
*3
II or less
2 or less
Self-cooling
Class D grounding (100
To be connected to the panel when grounding is not possible
to observe this instruction may cause a malfunction.
When the air inside the control panel is purged by pressurization, the surface sheet may be lifted by high
pressure. As a result, the touch panel may be difficult to press, and the sheet may be peeled off.
public electrical power distribution network and the machinery within the premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the raged voltage of 300 V is 2500 V.
equipment is used.
In pollution degree 2, only non-conductive pollution occurs but temporary conductivity may be produced due to
condensation.
Except 5V power supply type.
(when horizontally installed), 0 to 50
Frequency
Under 5 to 8.4Hz
intermittent
8.4 to 150Hz
vibration
Under 5 to 8.4Hz
continuous
8.4 to 150Hz
vibration
or less),
or less.
Specifications
(when vertically installed)
Acceleration
amplitude
- 3.5mm
2
9.8m/s
- 1.75mm
2
4.9m/s
2
, 11 ms, Sine half-wave pulse, 3 times
Half-
Sweep Count
10 times each
in X, Y and Z
-
directions
-
-