Mitsubishi Electric GOT 1000 User Manual page 187

Precautions for installing/removing the memory board
14.5.4 Error display
When copying is not available between the GOT and the memory board, check the following contents
according to the GOT error display.
Error message
The version of the standard monitor OS of
the GOT main unit does not match with that
of the project data in GT10-50FMB.
The model information does not match.
The write protection switch of GT10-50FMB
is ON.
There is no valid copy target data in the
copy source.
Touch
When installing or removing the memory board, be sure to power off the GOT main
unit.
The major version of the standard monitor OS of the GOT main
unit does not match with that of the project data in GT10-50FMB.
Match the version of the standard monitor OS of the GOT main unit
to the major version of the project data in GT10-50FMB.
The data selected as a copy target is not stored in GT10-50FMB.
Select the copy target correctly and copy it again.
The model set for the data in GT10-50FMB does not match with
that of the copy target GOT.
Use the same model data as that of the copy target GOT.
The write protection switch of GT10-50FMB is ON.
Turn off the write protection switch.
There is no data to be a copy target in the copy source.
Store the data to be copied in the copy source and copy it again.
9 Copy is completed.
Touch the ESC button to close the
screen. If an error occurs during copy, an
error message appears.
For details of error messages, refer to
the following.
Section 14.5.4 Error display
When only the project data was copied
to the GOT, touch the ESC button to
restart the GOT and display the user-
created screen.
When the standard OS was copied, the
GOT will automatically start up and
display the user-created screen.
(If the project data does not exist, a
message appears to notify that the
project data does not exist.)
Remedy
14.5 GT10-50FMB
14.5.4 Error display
9
10
11
12
13
14
15
16
14 - 10