Mitsubishi Electric GOT 1000 User Manual page 204

15.3.4 Precautions
(1) Inapplicable GOT
The FX list editor function cannot be used with the GT1030 and GT1020.
(2) Using other peripheral equipment for sequence program/parameter change
When using the MELSEC-FX list editor, do not change programs or parameters in the PLC CPU
from other peripheral equipment.
If you make a change, temporarily exit the MELSEC-FX list editor after the change is made, then
start the MELSEC-FX list editor again.
If you carelessly change the program on one PLC from multiple units of peripheral equipment
(including GOT), the contents of the program in the PLC CPU and the peripheral equipment may
not be the same, resulting in an unintended operation of the PLC CPU.
(3) Sequence program change
Stop the FX PLC before changing (writing, inserting, deleting) a sequence program or changing
parameters.
Operation is not possible with the FX PLC running.
(4) If you press the
search)
Check the input contents (applied instruction number, device value, etc.).
(5) When using list monitor
Only devices to be used for basic instructions can be monitored.
The status of devices (word, bit) to be used for application instructions cannot be monitored.
15 - 17 15.3 FX List Editor (For GT104[ ], GT105[ ] only)
15.3.4 Precautions
key but the system does not proceed to the next operation (for example, a
GO