4
Functions list and monitor conditions
The following shows the memory that can be monitored by the MELSEC-FX list editor and the FX PLC
status conditions.
Function
Displaying sequence
Reading
programs
sequence
Searching commands/
programs
devices
Writing
Writing commands
sequence
Changing operands/set
programs
values
Inserting commands
Deleting commands
Sequence program all clear
PLC diagnostics
Display
Parameter setting
Set
Keyword
*1
The operation is available only when the protect switch is OFF.
*2
The available memory differs depending on the FX PLC being used.
For further information, see the following manual.
15.3.3 Access range
The access range is the same as the access range when the GOT is connected to a controller.
Refer to the following manual for details of the access range.
GT Designer2 Version
GOT1000 Series Connection Manual (Mitsubishi Products) for GT Works3
(
: Can be monitored
Memory that can be monitored
Built-in
memory
The hardware manual of the FX PLC being used
Screen Design Manual
: Can be monitored under certain conditions
*2
EEPROM
memory
RAM memory
cassette, flash
cassette
memory
cassette
*1
*1
15.3 FX List Editor (For GT104[ ], GT105[ ] only)
: Cannot be monitored)
FX PLC
EPROM
Reference
status
memory
cassette
SubSection
RUN/
15.3.8
STOP
SubSection
15.3.9
SubSection
15.3.10
SubSection
15.3.11
For Stop
SubSection
only
15.3.10
SubSection
15.3.12
SubSection
15.3.13
SubSection
RUN/
15.3.14
STOP
SubSection
For Stop
15.3.15
only
RUN/
SubSection
STOP
15.3.16
15 - 16
15.3.3 Access range
9
10
11
12
13
14
15
16