Mitsubishi Electric GOT 1000 User Manual page 237

17. OS INSTALLATION
17.1 About the OS
GT10 is factory-installed with the BootOS, Standard monitor OS, and communication driver ([MELSEC-FX]).
Standard monitor OS is upgradeable from drawing software.
An installation of the communication driver is required when connected to a controller other than a MELSEC-FX.
(BootOS cannot be installed from drawing software.)
17.2 Standard monitor OS/
Communication Driver Installation
When installing the Standard monitor OS or communication driver, first bring up the OS installation screen on
the GOT, and then install the communication driver from drawing software.
Model
GT1020 BootOS version F or later
GT1030 BootOS version F or later
GT104
GT105
(1) About the OS installation screen
The OS can be transferred from GT Designer2 or GT Designer3 without displaying
the OS installation screen depending on the combination of the GOT and the
standard monitor OS
BootOS version Standard monitor OS
Standard monitor OS
[01.08.00] or later
From the first version
From the first version
For the installation using drawing software, refer to the following chapter.
GT Designer 2 Version
GT Designer 3 Version1 Screen Design Manual (Fundamentals)
(2) Checking method of BootOS, Standard monitor OS version
(a) Check the version of BootOS or Standard monitor OS installed in GOT at [OS
information] of the utility.
Refer to the following for details.
Section 14.2 OS Information
(b) Check the version of BootOS installed in GOT at product shipment on the
rating plate on GOT rear face.
GRAPHIC OPERATION TERMINAL
GT1030-LBD
MODEL
IN 20.4 26.4VDC POWER 2.2W MAX
S/N 710001 AA
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
GT Designer2
Version2.77F or later
Version2.90U or later
Version2.90U or later
Basic Operation/Data Transfer Manual
When the Boot OS version
is 2 digits, only the lower
digit is printed.
Example H/W version: H
AA
BootOS Version
GT Designer3
From the first version
Boot OS version: AD
Rating plate: HD
17.1 About the OS 17 - 1
17
18