Table of Contents
Advertisement
E 12
Set-up and modification
1
Special notes on safety
Danger to personnel by inadvertent starting of the engine, travel drive, conveyor, au-
f
ger, screed or screed lifting devices.
Unless otherwise specified, work may only be performed when the engine is at a
standstill!
- To protect the paver finisher against inadvertent starting:
Move drive lever into centre position and turn preselector controller to zero, remove
ignition key and battery main switch.
- Protect lifted vehicle parts (e.g. screed or hopper) against lowering by means of
mechanical safeguards.
- Replace parts or have them replaced as stipulated.
When connecting or disconnecting hydraulic hoses and when working on the hydrau-
f
lic system, hot hydraulic fluid may spurt out at high pressure.
Switch off the engine and depressurise the hydraulic system! Protect your eyes!
- Mount all protective devices before re-commissioning the paver finisher.
- The walkway must always reach over the entire working width of the screed.
The hinged walkway plate may only be folded up under the following conditions:
- When paving next to a wall or a similar obstacle.
- During transportation on a low-bed trailer.
DANGER
Danger due to changes at the vehicle
Structural changes to the vehicle make the operating
licence null and void and can cause severe to fatal injuries!
- Only use original spare parts and approved accessories.
- After maintenance and repair work, ensure that any dis-
mantled protective and safety devices are all completely
fitted again.
- Comply with all further information in these instructions
and in the safety manual.
E 12 1
Advertisement
Table of Contents
