Table of Contents
Advertisement
The Truck Assist system is used for communication between the driver of the paver
A
and the driver of the material truck. The corresponding signal system shows the truck
driver which action to perform (reversing / stop / tip material / depart).
NOTE
The lead cable must be plugged into the corresponding socket (A) on the right-hand
A
side of the machine.
Item Designation
Tell truck
84
to reverse
Tell truck
85
to interrupt
reversing - "STOP"
Caution! Possible material damage through
insufficient instruction
Ignored or incorrectly understood signals can cause
damage to the paver and/or material truck!
- The paver driver and all drivers of the material trucks
must be instructed in how the Truck Assist system works
and understand the system.
- Comply with all further information in the operating
instructions and in the safety manual.
Brief description
Pushbutton function with LED feedback:
- To change over to the "Start Revers-
ing" signal.
(GREEN SIGNAL)
- Press button again to change signal
over to "Stop".
Button LED (85) on
+ (RED SIGNAL).
- Press button once more to switch
again to "Start Reversing" signal.
(GREEN SIGNAL)
Button (39) can also be used to change
A
over to "Stop".
Pushbutton function with LED feedback:
- To change over to the "STOP" signal.
(RED SIGNAL)
Set "STOP" signal to interrupt procedure
A
or on reaching correct distance between
truck and paver.
LED display
D 12 35
Advertisement
Table of Contents
