Fuelling Pump (O) - Fayat Group Dynapac F2500W Operation & Maintenance Manual

Fuelling pump (o)

The fuelling pump must only be used to
m
pump diesel fuel.
Foreign bodies which are larger than the
m
mesh size of the intake cage (1) lead to
damage. An intake cage must therefore
always be used.
Each time fuelling is carried out, the in-
m
take cage (1) must be checked for dam-
age, and must be replaced if damaged.
Do not work without it under any circum-
stances, as the fuelling pump is not oth-
erwise protected against foreign bodies.
- Insert the suction hose (2) into the container which is to be emptied.
To enable the container to be emptied completely, the suction hose must reach down
A
to the floor of the container.
- Activate the function on the operating panel as necessary.
The fuelling pump does not shut off automatically. Therefore, never leave the pump
m
unattended when fuelling!
Never operate the pump without pumping a fluid. The risk of damaging your diesel
m
pump is run if it runs dry.
- To end fuelling, switch the function "off" on the operating panel.
- Place the end of the hose, with the intake cage, into its cup (3) so that no diesel is
able to escape into the environment.
- Gather up the hose and place it over the bracket (4).
(o)
2
4
1
3
D 31 39