Table of Contents
Advertisement
Item Designation
14
Starter
15
Drive lever
/
(traction)
16
Brief description
Starting is only possible when the drive lever is in the centre
position. All emergency stop buttons (on the operating panel
and the remote controls) must be pulled out.
For switching on the paver finisher functions and for continu-
ously regulating the road speed – forward or reverse.
Centre position: Engine in neutral; no travel drive;
- To swivel the drive lever out, release by pulling the
handle (16) up.
Depending on the position of the drive lever, the following
functions can be activated:
1. position:
- Conveyor and auger on.
2. position:
- Screed motion (tamper/vibration) on; travel drive on;
increase speed until the stop is reached.
Use the preselector to set the maximum speed.
A
The vehicle speed cannot be reduced to "0" with the
f
preselector. The vehicle advances slightly with deflect-
ed drive lever, even if the travel drive preselector is set
to zero!
If the engine is started with the drive lever pivoted out,
A
the travel drive is inhibited.
To be able to start the travel drive, the drive lever must
first be returned to the centre position.
When changing over between forwards and reverse
A
travel, the drive lever must remain briefly in neutral.
D 12 7
Advertisement
Table of Contents
