Table of Contents
Advertisement
Danger due to electric shock. Voltage flashover poses the risk of severe or fatal
f
injuries!
Heed the following safety distances to high-voltage lines:
< 125KV 5m
> 125KV 15m
The illuminated balloon must not be operated if the electric supply cables or
f
connectors are damaged.
Before starting up, check that the zip fastener of the balloon skin is closed. If the skin
m
is damaged, it must be repaired or replaced. The bulbs must be checked for firm
seating and damage.
The balloon cannot be operated with damaged skin.
A
Never operate the balloon unattended!
m
Maximum wind speed for using the balloon: 80km/h.
m
Installation and operation
- Fasten the illuminated balloon (1) to the holding tube (2) and pull the clamping lever
(3) tight.
- Close the zip fastener (4) in the balloon skin and smooth away any large wrinkles
in the skin.
- Guide the holding tube (3) into the premounted holder (5) and tighten the screws
(6) correctly to fix the holding tube.
- Once the illuminated balloon is completely mounted and secured, connect the plug
(7) of the illuminated balloon into the corresponding power sockets (8) in the switch
cabinet.
Operation of the switch cabinet - see screed operating instructions.
A
Route the supply lines so as to rule out any risk of stumbling or damage to the lines.
m
- After the illuminated balloon is connected up to the switch cabinet, it inflates
automatically.
- The skin of the illuminated balloon collapses again on being switched off.
- Remove the plug and open the zip of the balloon skin. Let the lamps cool down
completely.
- Store any dry illuminated balloons that are not needed in the corresponding
transport cover.
The holding tube most be removed during transport or to lower the roof!
m
D 31 41
Advertisement
Table of Contents
