Installing A Sata Solid State Drive In An Acx6160 - Juniper ACX6160 Hardware Manual

2. Wrap and fasten one end of the ESD grounding around your bare wrist and connect the other end of
the strap to the ESD point on the chassis.
3. Remove the eight captive screws securing the SSD cover plate by using the Phillips (+) screwdriver,
number 1. The SSD cover plate is located on the top of the chassis (see
Figure 32: Removing the SATA SSD Cover Plate
4. Remove the single screw holding the SATA SSD in place and slide the drive out of the plug (see
Figure 33 on page 85).
Figure 33: Removing the SATA SSD
5. Place the SATA SSD in an electrostatic bag or on an antistatic mat.
6. Place the SSD cover plate back on the chassis and tighten the eight captive screws securing the SSD
cover plate.

Installing a SATA Solid State Drive in an ACX6160

Before you install an SATA SSD in the device, ensure that you understand how to prevent ESD damage.
See "Prevention of Electrostatic Discharge Damage" on page
Figure 32 on page
128.
85
85).