Installing A Solid-State Disk In A T640 Re-C1800 Routing Engine; Figure 162: Removing An Ssd - Juniper T640 Hardware Manual

Installing a Solid-State Disk in a T640 RE-C1800 Routing Engine

Copyright © 2017, Juniper Networks, Inc.
Remove the cover from the Routing Engine slots.
5.
CAUTION: Do not remove the cover if any of the LEDs on the Routing
Engine faceplate are lit.
Press the eject button on the right side of the
6.
The SSD pops partially out of the slot. Grasp the SSD and carefully slide it completely
7.
out of the slot.
Place the SSD on the antistatic mat.
8.

Figure 162: Removing an SSD

To install an SSD in a Routing Engine (see
Insert the SSD into the
1.
CAUTION: Be sure to insert the SSD with the label facing down. Inserting
the SSD incorrectly might damage the Routing Engine.
Slide the SSD into the slot until you feel resistance, carefully ensuring that it is correctly
2.
aligned.
Reinstall the Routing Engine cover. Using a Phillips (+) screwdriver, number 2, tighten
3.
the screws on the corners of the cover to secure it to the Routing Engine .
From the master Routing Engine, power on the Routing Engine. For a standalone router,
4.
issue the
request system power-on other-routing-engine
Chapter 27: Replacing Host Subsystem Components
DISK1
Figure 163 on page
slot on the Routing Engine, with the logo facing down.
DISK1
slot to release the SSD.
330):
command.
329