Juniper ACX6160 Hardware Manual page 61

3. Align the holes in the mounting rail with the screw holes on the side of the chassis. The front bracket
is preinstalled in the rail. See
Figure 16: Attaching Front-Mounting Rails to the ACX6160
4. Attach the mounting rail to the device by using the mounting screws. Tighten the screws.
5. Repeat Step 3 and Step
6. Have one person grasp both sides of the device, lift it, and position it in the rack so that the front
bracket is aligned with the rack holes. See
7. Have a second person secure the front of the device to the rack by using four mounting screws (and
cage nuts and washers if your rack requires them). Tighten the screws.
Figure 17: Attaching the ACX6160 (with Mounting Rails to the Rack)
8. Continue to support the ACX6160 while sliding the rear-mounting blades into the channel of the
mounting-rails on the sides of the chassis and securing the blades to the rack. Use four mounting
Figure 16 on page 53
4 on the opposite side of the device.
Figure 17 on page
to see the proper alignment for the ACX6160.
53.
53