Juniper ACX6160 Hardware Manual page 94

Ensure that you have the following parts and tools available to install an SATA SSD in the ACX6160:
• ESD grounding strap
• Phillips (+) screwdriver, number 1
• An electrostatic bag or antistatic mat
To install a SATA SSD in an ACX6160:
1. Wrap and fasten one end of the ESD grounding around your bare wrist and connect the other end of
the strap to the ESD point on the chassis.
2. If not already removed, remove the eight captive screws securing the SSD cover plate by using the
Phillips (+) screwdriver, number 1. The SSD cover plate is located on the top of the chassis (see
34 on page 86).
Figure 34: Removing the SATA SSD Cover Plate
3. Slide the drive into the SSD plug and tighten the single screw holding the SATA SSD. (see
on page 86).
Figure 35: Installing the SATA SSD
86
Figure
Figure 35