Table of Contents
Advertisement
Installation Guide Linear Motors
Slider front end:
M10 thread + cut-in
Slider mounting kits
6.5.1 Fixed bearing
Item
Item No.
PLF01-28
0150-3297
(Stainless-st.)
6.5.2 Floating bearing
NTI AG / LinMot
Slider back end:
M8 thread
Slider mounting kit consists of a spring washer, a pair of spherical
washers, and a pair of conical seats. It allows the slider to be fixed
in the direction of motion. It also helps to compensate for radial and
angle offset.
Material
Spherical washer / conical seat: case hardened steel
Slider
Thread
28mm
M10
Floating bearing assembly that permits radial adjustment of slider
position and permits a small amount of radial and axial movement.
P10-70-SSC / P10-70-SSC-Dxx
Checking the installed direction of slider
After the installation, the front end of the slider
with M 10 thread and cut-in is located at the
opposite side of the stator from the cable exit.
Slider back end should not be used for
load mounting!
d1
d2
10.5mm
12mm
(0.41in)
(0.47in)
ENG
d3
h
21mm
6.5mm
(0.83in)
(0.26in)
Page 29 / 44
Advertisement
Table of Contents
