Electrical Connection; Technical Data Of Motor Cables - LinMot P10-70-SSC-D Series Installation Manual

Installation Guide Linear Motors

5 Electrical connection

Do not connect or disconnect motor when there is power on the servo drive.
Use only double-shielded original LinMot cable. Cables from other sources must be
checked precisely before commissioning.
Incorrect connections can destroy the drive and stator.

Technical Data of Motor Cables

For the linear motors of the P10-70 series, different cable types are used for the power and signal supply,
depending on the use of the drive type (LinMot or third-party manufacturer). All cables are high-flex cables
(suitable for trailing chains) and are used for both fixed and moving applications.
Type KPS15-04
LinMot drives +
Application for
Third-party drives
Minimum
bending radius 50 mm
for fixed (2 in)
installation
100 mm
Minimum
(4 in)
bending radius
when moving
No torsion
Max. Cable
length
Approval
UL / CSA 1000V
Wire isolation: TPE
Material
Jacket: PUR
Oil resistance sehr gut
Chemical
resistance (to
acids, alkalis, good
solvents,
hydraulic fluid)
Outdoor
very good
durability
Flammability flame retardant
Page 18 / 44
Power cable
KPS15-04/04
Third-party drives
60 mm
(2.36 in)
120 mm
(4.72 in)
No torsion
30 m (can be limited by the servo drive)
UL / CSA 1000V /
300V
Wire isolation: TPE
Jacket: PUR
sehr gut
good
very good
flame retardant
P10-70-SSC / P10-70-SSC-Dxx
Encoder cable
KSS05-02/08 KSS05-02/13
LinMot drives Third-party drives
50 mm 45 mm
(2 in) (1.75 in)
100 mm 90 mm
(4 in) (3.54 in)
No torsion No torsion
UL / CSA 300V UL / CSA 30V
Wire isolation:TPE Wire isolation: PE
Jacket: PUR Jacket: PUR
sehr gut sehr gut
good good
very good very good
flame retardant flame retardant
NTI AG / LinMot
ENG